|
The Rhode Island 4-H
Show Box |
|
|
Step 6: To assemble the Front #23, to Ends #21,
lay out screw lines as shown on sketch J.
After these lines are laid out mark for screws about 1” apart. Coat End and Side Frame that comes in
contact with Front with a liberal amount of glue. Carefully place Front in position as shown on Sketch J, nail with 2 or 3 2-penny finishing
nails to hold End and Front together.
Drill and countersink holes and screw End and Front together using the
#9 1/34/” screws. |
Step 7: Repeat the above directions to assemble Back #24 to other End. Step 8: Now assemble the Front to the Back using the same method. Step 9: Turn the Box upside down; Layout screw lines as shown on Sketch K. Mark off screw locations about 1” apart, coat Front, Back, Ends and Bottom of Frames with a liberal about of glue, position as shown and nail to hold in position. Drill and countersink screw holes and using the #9 1 ¾” screws, fasten Bottom to Box.
|
|
|
|
